• Motorola Solution Partner
  • Freelinc

Subscribe

  • Twitter link
  • Facebook link
  • RSS feed link

VHF and UHF FM Repeaters

Icom IC-FR3000 Series

Bridging the gap between bands

 

 

 

50 Watt continuous full duty cycle operation

This repeater looks as good as it performs. A rugged heatsink, large cooling fans and a high performance power module provide the repeater with a stable 50W at full duty cycle operation.

 

Automatic battery backup system

A built-in backup system supports automatic switching to an external power supply (13.6V DC) if the AC power supply fails.

 

Multiple CTCSS & DTCS tone memories with multiple memory channels

Up to 16 CTCSS/DTCS tones (TX/RX tones respectively) can be programmed in a channel. This feature allows you to share a channel with multiple user groups. You can also give priority/exclusive use to a specified group simply by programming different tones to another memory channel. Ideal for many different applications.

 

Built-in 2-Tone, 5-Tone, DTMF encoder & decoder

Multiple signaling systems are equipped as standard. These systems are fully compatible with Icom F-series radios.

 

Internal space for duplexer and isolator

The repeater has an internal space to install a duplexer and isolator*. The controls of the duplexer are accessible from the front of the repeater without disassembly. Faster and easier maintenance and adjustment is possible.

* Ask about details about available duplexers and isolators.

 

Telephone interconnect capability

 

DTMF remote control capability

You can control the repeater from a remote location over the air or over a phone line with DTMF.

 

Additional Features

Master/Slave backup operation by connecting two repeaters

Self check function checks for internal errors and alerts with a beep sound or with a phone call

Accessory connector (D-sub 25-pin) on the rear panel for trunking controller including LTR™ and PassPort®

Compatible with VEGA tone remote control system

5-Tone relay function

Optional Voice Scrambler UT-109 or UT-110

CW ID transmitter (DTMF or 5-Tone also selectable)

Password and kill/stun function for security

16-digit alphanumeric display convenient for base station operation

A programmable button gives access to a customized function

Specifications

General

Frequency coverage (MHz)

IC-FR3000

IC-FR4000

 

148-172MHz, 150-174MHz

400-430MHz, 430-450MHz, 450-480MHz

No. of channels 32 channels
Channel spacing 12.5/25KHz
PLL channel step 5, 6. 25KHz (2.5kHz, VHF repeater operation only)

Frequency stability

VHF

UHF (U.S.A. version)
UHF (Other versions)

±2.5ppm

±1.5ppm < /br> ±2.5ppm

Operating temperature range

-30°C to +60°C

-22°F to +140°F

Power supply voltage

13.6V DC 
100-120V AC (50/60Hz)*,

220-240V AC (50/60Hz)*
*Depending on version

Current drain (at 13.6 V DC)
Tx

Rx


VHF (at 50W)
UHF (at 50W)
Max. audio
Stand-by


15A
20A
2A typ.
1A typ.

Antenna impedance 50Ω (Type-N × 2)
Dimensions (proj. not incl.)

410(W) × 110(H) × 360(D) mm

16 532 × 4 1132 × 14 316 in

Weight 12 kg; 26.4lb (approx.)
Transmitter
Output power 50W (high), 10W (low) selectable (at 13.6V DC)
Max. frequency deviation ±5.0kHz/±2.5kHz (wide/narrow)
Spurious emissions 70dB
Adjacent channel power 70/60dB (wide/narrow)
Hum and noise 40/34dB (wide/narrow)
Microphone impedance 600 ohm (8-pin modular)
Receiver
Sensitivity 0.25µV typ. (at 12dB SINAD)
Adjacent channel selectivity 70/60dB (wide/narrow)
Spurious response 70dB
Intermodulation rejection ratio 70dB
Hum and noise ratio 40/34dB (wide/narrow)
Audio output power 2.5 W typ. at 10% distortion with a 4 ohm load
External speaker connector 2-conductor 3.5 (d) mm (18″)/4Ω

Applicable U.S. Military Specifications

Icom makes rugged products that have been tested to and pased the following MIL-STD requirements and strict environmental standards.

Standard

MIL 810C MIL 810D MIL 810E MIL 810F
Method Proc. Method Proc. Method Proc. Method Proc.
High Temp. 501.1 I 501.2 I, II 501.3 I ,II 501.4 I, II
Low Temp. 502.1 I 502.2 I, II 502.3 I, II 502.4-3 I, II
Vibration 514.2 VII, X 514.3 I 514.4 I 514.4 I
Shock 516.2 I, II, IV 516.3 I, IV 516.4 I, IV 516.5 I, IV

Measurements made in accordance with EIA/TIA-603-A. Compatibility of functions for use with a telephone line may not work in some countries. All stated specifications are subject to change without notice or obligation.

Manufacturers

IPTEL NETWORK INC.  -  14359 Miramar Parkway # 261  -  Miramar, FL 33027  -  Mobile: 305-793 5864  -  Office:305-823 8860  -  Fax: 754-400 8346